Custom Lathe Workholding for a Large Ring
The operator shows a large ring, a custom gripping arrangement on the lathe and a fixture ring used before drilling and milling the side features.
Chapters
Selected chapter: Custom grip and turning
Engineering notes
Mark the locating surfaces used when transferring the ring between setups. Confirm support, clamping pressure, stock allowance and finish requirements for the actual geometry.
Related engineering knowledge
Transcript
The machining sequence included making the fixtures for these rings.
We used two setups on the lathe.
There was a five-axis setup, followed by a flip to reach the back.
We made a large gripping fixture on the lathe to hold the ring.
We turned a small step for the plate, then clamped that end to turn the inside and outside.
We changed the plate position to finish the opposite end.
The ring then went on to five-axis machining.
We made a fixture ring, secured the part and machined features around the side.
We left extra stock on the inside and outside because the starting size was not an exact fit.
The outside still needs a paint finish.
What do you think of this job?