Turning and Milling in One Process Plan
Compare how the shop holds round parts during turning and repositions them to reach features with a mill.
What you’ll learn
Engineers specifying shafts, rings and round components with milled features.
- Distinguish rotational surfaces from features that need off-axis access.
- Identify the purpose of leaving a surface for later clamping.
Episodes
-
Rotary Workholding for a Cylindrical Housing
The operator shows a cylindrical housing in a chuck, then presents a supported machining setup and a rotary fixture that gives the tool access to side openings.
-
Turning and Milling a Cylinder with Internal Slots
The operator identifies the non-circular internal profile and trapezoidal thread, then shows the turning and milling setups used on the same part.
-
Custom Lathe Workholding for a Large Ring
The operator shows a large ring, a custom gripping arrangement on the lathe and a fixture ring used before drilling and milling the side features.
-
Workholding a Ring with Multiple Bores
The operator presents a large ring, then shows the turned surfaces and the milling setup for the openings. The sequence changes how the work is supported as the remaining material is removed.
-
Reclamping a Turned Cylinder for Off-Axis Features
The clip follows a cylindrical workpiece through a lathe chuck and a second fixture. The operator shows how a different orientation provides access to features away from the turning axis.