Workholding a Ring with Multiple Bores
The operator presents a large ring, then shows the turned surfaces and the milling setup for the openings. The sequence changes how the work is supported as the remaining material is removed.
Chapters
Selected chapter: Milling setup
Engineering notes
Confirm which circular surfaces establish the locating datum for the later milling setup. Workholding pressure and distortion limits depend on the part.
Related engineering knowledge
Transcript
The stock for each part cost 1,000 yuan.
Programming and machining took six shifts.
The openings have milled curves. The small
holes are normal to the large face.
This was done on this machine.
First, turn the inside and outside on a
lathe.
Rough the ring before finishing. A part
this large can deform.
We used two setups on a three-axis mill.
For the first setup, support these corners
with shims and mill this face.
Then flip it and clamp it at three points.
These curved surfaces were all milled.
Two setups on the mill and two on the
lathe. One of the three parts is still in
the machine.
What do you think of the job? What would
the rate be?