Reclamping a Block to Mill Multiple Faces
The operator compares the starting block with the machined part, then shows how the block is turned over to reach features on another face.
Chapters
Selected chapter: Turning the part over
Engineering notes
Review which faces can be used to locate and support the block in each setup. Check the drawing for dimensions and relationships between features on opposite faces.
Related engineering knowledge
Transcript
We made ten parts. Programming and
machining took 12 hours.
They also need anodizing. We ordered two
blocks of stock.
There were two five-axis setups and one
three-axis setup for the opposite face.
Use this machine and leave the stock
thicker.
Mill one part at a time from the stack.
Ten parts came from two blocks.
Face the block and mill the top.
Drill the holes and machine the slots.
Flip it over and drill the holes around
the rim.
Cut it free and finish the small side
holes.
The outside profile and slots have their
own tolerances.
We made ten parts. What do you think each
one is worth?