Supporting a Housing During Pocket Milling
The operator presents a pocketed housing, shows how it is flipped in the machine and points out a shaped support used during machining.
Chapters
Selected chapter: Shaped support
Engineering notes
Review the order of stock removal and which surfaces stay supported during each cut. Wall thickness and final flatness should be checked against the part drawing.
Related engineering knowledge
Transcript
Stock was 340 yuan. Programming and
machining took seven and a half shifts.
The curved base and thin wall made the
work time-consuming.
This side is curved too, and all six faces
need machining.
The part also needs anodizing. We used
this machine.
Leave the stock thick enough to clamp at
the base, then mill the outside profile.
Leave this side solid for now. Flip the
part and face it to thickness.
Stand it up and mill the slots along the
four sides.
Flip and clamp it again to machine the
pocket on this side.
Make a fixture with the opposite shape so
it supports this surface closely.
Rough the remaining material, then finish
the curved surface.
Another part is still in the machine. What
would you charge for the job?