Indexed Machining for a Forked Bracket
The operator shows a forked bracket, its indexed setup and how different orientations expose the side features and a bore from below.
Chapters
Selected chapter: Bore access
Engineering notes
Before releasing the design, check which reference surfaces remain accessible after indexing. Confirm the bore size and its position from the drawing rather than from the demonstration.
Related engineering knowledge
Transcript
Stock, including the clamping allowance,
was 25 yuan. We made ten parts.
Programming and machining took just over
two shifts on this machine.
We indexed the part to reach these faces.
These two holes were machined upward from
this face.
Start with larger stock and mill the
profile with a 2D toolpath.
Mill the slots and holes on both sides,
then tap the threads.
Index the part to finish this face. The
two slots are normal to the angled face.
That is awkward on three axes. On five
axes, index the part for access.
Chamfer the edges and mill out the inner
cavity.
These two holes are machined from the
opposite face.
What do you think of this job? What would
you charge?