Profile and Slot Milling for a Grid Panel
The operator shows the grid panel during external profile machining, then shows the narrow slots and the T-slot cutter setup. The last view shows the finished part.
Chapters
Selected chapter: Narrow slots
Engineering notes
Flag undercuts and narrow tool access in the drawing. Plan clamping around thin walls and verify fit and flatness on the finished part.
Related engineering knowledge
Transcript
The stock for this job cost 130 yuan. We
made four parts.
Programming and machining took 25 hours.
This side slot needs a T-slot cutter. Five
faces need machining.
The part needs anodizing. I used this
machine.
Start with thicker stock, clamp it and
mill the outside profile.
Mill these two pockets.
Leave the small lower slots intact at this
stage.
Finish the ledge and drill the holes.
Flip it over and face it to thickness.
Then mill out the small slots.
The center is thin. Too much clamping
pressure deforms it.
Too little pressure lets it move. I added
two dots of adhesive on the back for
support.
For the last setup, stand it up. Mill the
slot with a flat cutter, then finish with
the T-slot cutter.
Drill the row of holes, then reposition it
for the side holes.
Three of the four parts are here. One is
still in the machine.
What do you think each part is worth?