Staged Roughing and Side Access for a Bracket
The operator presents a bracket, roughs the pocket and then changes the setup to reach side features and a curved surface.
Chapters
Engineering notes
List which features need access from each orientation. Check that the remaining stock and fixture leave room for the tool and protect the reference surfaces.
Related engineering knowledge
Transcript
We made ten parts. Programming and
machining took a little over two shifts.
This was made on this machine. Start with
dynamic roughing.
Drill the four holes and mill the features
on this face.
Index the part to reach these holes and
the side features.
Index it again to mill this area and its
curved surface.
Turn it to reach the curved surface on the
back.
Cut the part free. This is the clamping
area underneath.
I would use three axes next time, even
with more setups. Five axes used more
stock here.
What do you think of the job? What would
you charge?