Leaving Center Stock During Ribbed-Panel Milling
The operator calls out anodizing before showing the machining sequence. The clip follows the panel from clamping through stock removal.
Chapters
Selected chapter: Anodizing requirement
Engineering notes
Indicate cosmetic faces, masking and acceptance criteria on the drawing. The video shows the machining sequence and identifies the finish requirement. Ask the finishing supplier to confirm the actual anodizing specification.
Related engineering knowledge
Transcript
Stock cost 290 yuan. The two parts took
five shifts, including programming and
setup.
The part needs anodizing, and there is
machining on all six faces.
Clamp the part and mill the outside
profile.
Face it and machine the two slots and the
locating features.
Keep the center solid at this stage.
Hollowing it early causes vibration.
Stand it up and mill the small side slots,
then drill the holes.
Flip it to work on the other side. Rough
out this section.
Open the two slots and machine the long
slot.
Flip it again and remove the stock from
the center.
Finish the groove. We made two parts.
What do you think of the job?